- #Mac home network security how to#
- #Mac home network security install#
- #Mac home network security windows 10#
- #Mac home network security software#
#Mac home network security windows 10#
Now to change the computer's IP address (we take Windows 10 as an example):ġ) Press the Windows + R keyboard shortcut to bring out the Run box.Ģ) Enter ”ncpa.cpl” and open the ”Network Connections” window.ģ) Right-click your computer’ network adapter and select ”Properties”.Ĥ) Select your computer's Internet Protocol Version and click ”Properties”.ĥ) Select ”Use the following IP address” and change the IP address into 192.168.177.12.Īnd done. All nodes on a given network share the same network prefix but have a unique host number. IP address 101: An IP address consists of two parts – one belongs to the network address and one belongs to the node address. So let's say the computer's IP address is 192.168.177.12. In our test, the default IP address of the camera we use is 192.168.177.100, and now you need to change your computer's IP address to, where x identifies the node/host and is the number between 2 and 254. So in Step 3, you get your security camera's default IP address. Change the computer's IP address to the same network prefix of the IP camera. Launch it and it will automatically scan all the cameras in the same local LAN and show the default IP address (every camera has a default and unique IP address when it leaves the factory).
#Mac home network security software#
There should be surveillance software from the same supplier with the camera. What you need to do now is to scan and find out the camera's IP address. But you still can't view the camera on the computer. Now the security camera is connecting to your computer basically and physically.
Scan and find out the security camera's IP address on the computer.
If your computer has a network already, disable it – make sure your computer is offline. Then connect the other end of the network cable to the computer. Find the network connector from that cable and use the network cable to connect to it. Normally there would be a 2-in-1 or 3-in-1 cable attached from the camera. Use the network cable to connect to the camera and the computer. For a PoE camera, ask the supplier and buy one that's workable for the camera. Normally, when you buy a WiFi IP camera, it comes with a power adapter. Use the power adapter to get the camera plugged-in and charged. You need to prepare the camera's power adapter and a network cable.
#Mac home network security how to#
Here's how to connect your security IP camera directly to a PC/Mac without an NVR or DVR, without a router network, without WiFi, and without any costs or complicated configurations. Important Note: The methods recommended below may NOT apply for the battery-powered security cameras, which require initial setup on your phones.Ĭonnect a WiFi or PoE Camera Directly to PC/Mac (without Internet) PoE (Wired) Camera without Injector/Switch Connect Directly to PC/Mac (without Internet)
To make it easier for you to find the right solution, you can click and jump directly to the section you want.įor example, if your camera is a PoE camera, then you can choose option 3 or 4. 5 Methods to Connect Your Security IP Camera to PC/Mac：
#Mac home network security install#
You can refer to How to Install Home Security Cameras Successfully. Note: First you should install the security camera in the right place. Camera types:Ģ-in-1 or 3-in-1 cable attached from the camera The following table summarizes the important information about connecting IP camera to your computer for your reference. And we will cover the steps on how you should do it without a router, without internet, without a DVR/NVR or without its receiver. In this article, there are 5 ways you can connect your Security IP Camera to your computer.
0 kommentar(er)
